IronRidge TM-FTL-015 Fixed Tilt Leg, Mill 15 Inch

IronRidge TM-FTL-015 Fixed Tilt Leg, Mill 15 Inch

Introduction

The IronRidge Tilt Mount System supports a wide range of solar module tilting angles, while also resisting the extreme wind and snow forces experienced over a building’s lifetime. Every component has been carefully engineered and rigorously tested, and the entire system uses only aluminum and stainless steel materials to resist corrosion.

Tilt assembly to desired angle, up to 30 degrees. Kits include South and North Tilt Leg and all hardware. Available in multiple lengths for a wide angle range, assembled South Tilt Legs include angle indicators and legs are electrically bonded to rails.

Variations

• IronRidge TM-FTL-007 Fixed Tilt Leg, 07", Mill
• IronRidge TM-FTL-010 Fixed Tilt Leg, 10", Mill
• IronRidge TM-FTL-015 Fixed Tilt Leg, 15", Mill
• IronRidge TM-FTL-020 Fixed Tilt Leg, 20", Mill
• IronRidge TM-FTL-025 Fixed Tilt Leg, 25", Mill
• IronRidge TM-FTL-030 Fixed Tilt Leg, 30", Mill

Contains

• 1 U Foot
• 1 North Tilt Leg, 1.5" SQ, 20 inch fixed tilt leg
• 1 Pre-assembled South Tilt Leg
• 3 Nut, Flange Hex 3/8-16 SS
• 1 Washer, Flat 3/8 SS
• 1 Bolt, 3/8-16 x 2.5"CS SST
• 1 Bolt, Bonding 3/8-16 SQ Head, 2.25"
• 1 Bolt, Bonding 3/8-16 SW Head, 1.0"

Attachments

• IronRidge Tilt Leg Cut Sheet
• IronRidge Tilt Mount Installation Guide