Blog
Which inverters will Enphase Microinverters work with?
Posted by Frank Molina, Stellavolta on Aug 10th 2020
Enphase Microinverters work with a number of battery-based inverter manufacturers and component manufacturers, including Magnum Energy, Outback Power Systems, MidNite Solar, SMA, and Schneider Electri
Will the Schneider Electric Conext XW+ Inverter automatically switch between the grid and battery bank?
Yes, the Schneider Electric Conext Inverter can switch between grid power and battery power automatically. In addition, if the batteries reach the Low Battery Cut Out setting, the Conext XW+ automatic
Read More »
Will the MidNite Solar CLASSIC and SL Charge Controllers pick up ground faults in the solar panel wiring?
Yes, the MidNite Solar CLASSIC and SL solar controllers will pick up grounds faults in the solar panel wiring. It detects positive current on the ground side. If one of the solar panels is throwing a
Read More »
Will the SMA Sunny Boy Storage Battery Inverters work with sealed lead acid (SLA) batteries?
No, the SMA Sunny Boy Storage Battery Inverters will only work with high voltage batteries.
Read More »
TECHNICAL NOTE: Sunny Boy US-41: Secure Power Supply Operation with TS4-R-O
PURPOSE
This notice provides instructions for installing the Secure Power Supply for a Sunny Boy PV system outfitted with SMA TS4-R-O devices.
APPLICABLE PRODUCTS
Sunny Boy 3.0 / 3.8 / 5.0 / 6.0
Read More »
How loud is the Primus 1-ARSM-15 Air Silent X Wind Turbine?
They are about 40 dB and are more quiet than Air 40 blades which produce a maximum of 65 dB.
Read More »
What circuit breaker amperage do I need?
A basic rule of thumb is to multiply the solar panel's Short Circuit Current by 1.25. This may be more complex, however, depending on your system design.
Read More »
Are the SMA Sunny Boys UL-1741 certified?
Yes, in addition to compliance with NEC 2017, the new inverters are compliant with California Rule 21 Phase 2 and UL 1741.
Read More »
Can the Cotek CX2440 Battery Charger plug into a 120V wall outlet?
Yes, the Cotek CX2440 Battery Charger can be plugged into a 120V wall outlet. They are universal ac input, so they can accept anywhere from 90-264 VAC.
Read More »
At what voltage does the Morningstar SS-MPPT-15L SunSaver Solar Controller begin to charge batteries?
Before connecting the battery, measure the battery voltage. It must be over 7 volts to power the controller. For 24 volt systems, the battery voltage must be greater than 15.5 volts to properly detect
Read More »